Brigade Backeye 360 Select - Configuring the View Select Button Operation

37
To exit the menu and save the changes, press the MENU button
on the remote control once to return to the menu home screen and
then again to exit.
Note: there is a short delay when exiting the menu as the system
saves the changes that have been made. Wait approx. 10 seconds
for the system to exit the menu.
Restart the system to “activate” the changes (turn vehicle ignition
on/off).
Configuring the View Select Button Operation
To change the behaviour of the View Select Button, enter the OSD SETUP menu by pressing the
MENU button and pressing OK on the SETUP icon.
Press the TAB up button to select the View Select Button option.
(Alternatively press the TAB down button 6 times)
Press the arrow buttons on the remote control to change the
selection.