8
Camera Fitting Kit - BN360-100C-FIX
The fitting kit contains all the required fixing components for fitting the cameras to
a vehicle. This consists of self-tapping screws, machine screws and nuts & screw
caps.
Isolation Gasket Kit – BN360-100C-MK
The mounting gasket kit stops vehicle noise or interference that may disturb the
camera image by insulating the camera and its body from the vehicle ground.
Calibration Tools
The following is a list of the components that are required to calibrate the Backeye360° products.
Calibration Tool – BN360-CT-01
Used for transferring data (e.g. calibrations, capture images, backup data etc.)
between the ECU and PC from data saved on an SD card.
Calibration mats (4 off) – BN360-CAL-MAT
These mats are aligned around the vehicle to perform the camera calibration for the
360° surround view image.
The USB contains all documentation, software and support files required to install
and calibrate the BN360-200 system, including the Brigade Backeye® 360° Select
Calibration Software.
For the latest USB contents please contact Brigade Electronics.
To Next Page
Loading...
