EasyManuals Logo

Brocade Communications Systems FastIron User Manual

Brocade Communications Systems FastIron
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #134 background imageLoading...
Page #134 background image
Example for setting the IPv4 hitless purge timer on the non-default
VRF
The following example shows how to set the IPv4 purge timer on the non-default VRF:
Brocade(config)# vrf blue
Brocade(config-vrf-blue)# rd 10:10
Brocade(config-vrf-blue)# address-family ipv4
Brocade(config-vrf-blue-ipv4)# ip hitless-route-purge-timer 60
Setting the IPv6 hitless purge timer on the defatult VRF
To configure the purge timer, enter the ipv6 hitless-route-purge-timer command in global
configuration mode.
Example for setting the IPv6 hitless purge timer on the defatult VRF
The following example shows how to set the IPv6 hitless purge timer on the default VRF:
Brocade(config)# ipv6 hitless-route-purge-timer 60
Setting the IPv4 hitless purge timer on the non-default VRF
Before you begin: Enable IPv6 unicast routing using the ipv6 unicast-routing command in global
configuration mode.
1. Enter the VRF configuration mode using the vrf command.
2. Configure route distinguisher using the rd command.
3. Enter the IPv6 address family configuration mode using the address-family ipv6 command.
4. Configure the router purge timer using the ipv6 hitless-route-purge-timer command.
Example for setting the IPv6 hitless purge timer on the non-default
VRF
The following example shows how to set the IPv6 purge timer on the non-default VRF:
Brocade(config)# vrf blue
Brocade(config-vrf-blue)# rd 10:10
Brocade(config-vrf-blue)# address-family ipv6
Brocade(config-vrf-blue-ipv4)# ipv6 hitless-route-purge-timer 60
Energy Efficient Ethernet
Energy Efficient Ethernet (EEE) regulates and saves power consumed by the active hardware
components in the switch and conserves power during idle time.
EEE allows Brocade devices to conform to green computing standards. This functionality is achieved
by moving the data ports to a low-power state when their function is not necessary or when they are in
Example for setting the IPv4 hitless purge timer on the non-default VRF
134 FastIron Ethernet Switch Administration Guide
53-1003625-01

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron and is the answer not in the manual?

Brocade Communications Systems FastIron Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron
CategorySwitch
LanguageEnglish

Related product manuals