Brocade Communications Systems FastIron - System Monitoring for Packet Processors

action
Specifies the action to take when the error count exceeds the specified threshold and log
back-off values.
none
No action is taken.
syslog
The error is logged to syslog.
Modes
Global configuration mode.
Usage Guidelines
This command is supported only on FSX devices.
Examples
The following example configures system monitoring for cross bar link errors:
Brocade(config)# sysmon xbar link threshold 3 7
Brocade(config)# sysmon xbar link action syslog
Brocade(config)# sysmon xbar link log-backoff 15
System monitoring for Packet Processors
On FSX devices, errors typically detected in packet processors include:
• Parity errors
• Error Checking Code (ECC) errors
• ConfigTable0 errors
• TCAM error
• TCAM action parity errors
• Token bucket priority parity errors
• State variable parity errors
• Link list RAM ECC errors
• FBUF RAM ECC errors
• Egress VLAN parity errors
• Ingress VLAN parity errors
• Layer 2 port isolation parity errors
• Layer 3 port isolation parity errors
• VIDX parity errors
Besides the error count, sysmon also checks for connectivity of SFM/XBAR links. This happens at the
interval defined by the sysmon-timer command generally or specifically for cross bar.
Use the following commands to configure and display the statistics of cross bar or switch fabric module:
• sysmon pp error-count on page 276
• show sysmon logs on page 278
• show sysmon counters on page 278
• show sysmon config on page 282
System monitoring for Packet Processors
FastIron Ethernet Switch Administration Guide 275
53-1003625-01