Examples
The following example configures system monitoring for fabric adaptor errors:
Brocade(config)# sysmon fa error-count threshold 3 7
Brocade(config)# sysmon fa error-count action syslog
Brocade(config)# sysmon fa error-count log-backoff 15
sysmon fa link
Configures system monitoring for link errors on all or specified fabric adaptors. The no form of this
command resets the parameters to default values.
Syntax
sysmon fa link { threshold events polling-interval | log-backoff value | action { none | syslog } }
no sysmon fa link
Parameters
threshold
Defines the failure threshold for the fabric adapter link error event. The threshold is defined
as N/W, where N is the number of events, and W is the number of consecutive polling
periods. When the threshold is reached, actions configured for this event type will take
place. Note that a threshold of 1/W implies that there is no threshold, and no event will be
triggered.
events
Specifies the threshold in terms of the number of events. Valid values are 1 through
10.
polling-interval
Specifies the number of polling windows. The device polls the internal registers at the
interval specified by the sysmon timer value. Valid values 1-32. However, the polling
window number must be equal or greater than the number of events.
log-backoff
If an error condition persists, it will be continuously logged (internally and/or externally). The
log back-off count skips configured number of logs before logging again. This avoids
overflow of the internal log or of the syslog.
action
Specifies the action to take when a fabric adapter link error exceeds the specified threshold
and log back-off values.
none
No action is taken. This is the default.
syslog
The error is logged to syslog.
Modes
Global configuration mode.
Usage Guidelines
This command is supported only on FSX devices.
sysmon fa link
272 FastIron Ethernet Switch Administration Guide
53-1003625-01
To Next Page
Loading...
Need help?
General
