Syslog for port shutdown prevention
Describes the syslog for port shutdown prevention.
<14>0d01h38m44s:<product type>: port <port-num> detect loop, ignoring shut down event in
shutdown-disable mode.
CLI banner configuration
Brocade devices can be configured to display a greeting message on users’ terminals when they enter
the Privileged EXEC CLI level or access the device through Telnet.
In addition, a Brocade device can display a message on the Console when an incoming Telnet CLI
session is detected.
Setting a message of the day banner
You can configure the Brocade device to display a message on a user terminal when a Telnet CLI
session is established.
For example, to display the message “Welcome to FESX!” when a Telnet CLI session is established.
Brocade(config)# banner motd $ (Press Return)
Enter TEXT message, End with the character '$'.
Welcome to FESX! $
A delimiting character is established on the first line of the banner motd command. You begin and end
the message with this delimiting character. The delimiting character can be any character except
“ (double-quotation mark) and cannot appear in the banner text. In this example, the delimiting
character is $ (dollar sign). The text in between the dollar signs is the contents of the banner. The
banner text can be up to 4000 characters long, which can consist of multiple lines.
Syntax: [no] banner motd delimiting-character
To remove the banner, enter the no banner motd command.
NOTE
The banner delimiting-character command is equivalent to the banner motd delimiting-character
command.
When you access the Web Management Interface, the banner is displayed.
Syslog for port shutdown prevention
86 FastIron Ethernet Switch Administration Guide
53-1003625-01
To Next Page
Loading...
Need help?
General
