Brocade Communications Systems FastIron User Manual

F 641 startup-config.txt
F 391 stacking.boot
F 76942 debug.boot
F 638 startup-config.backup
F 0 startup-config.no
56232476 bytes 7 File(s) in FI root
1771020288 bytes free in FI root
1771020288 bytes free in /
Syntax: show files
To display the contents of a flash configuration file, enter a command such as the following from the
User EXEC or Privileged EXEC mode of the CLI:
device#copy flash console startup-config.backup
ver 07.0.00b1T7f1 !
stack unit 1
module 1 fcx-24-port-management-module
module 2 fcx-cx4-2-port-16g-module
module 3 fcx-xfp-2-port-10g-module
priority 80
stack-port 1/2/1 1/2/2
stack unit 2
module 1 fcx-48-poe-port-management-module
module 2 fcx-cx4-2-port-16g-module
module 3 fcx-xfp-2-port-10g-module
stack-port 2/2/1 2/2/2
stack enable
!
!
!
!
vlan 1 name DEFAULT-VLAN by port
no spanning-tree
metro-rings 1
metro-ring 1
master
ring-interfaces ethernet 1/1/2 ethernet 1/1/3
enable
!
vlan 10 by port
mac-vlan-permit ethe 1/1/5 to 1/1/6 ethe 2/1/5 to 2/1/6 no spanning-tree !
vlan 20 by port
untagged ethe 1/1/7 to 1/1/8
no spanning-tree
pvlan type primary
pvlan mapping 40 ethe 1/1/8
pvlan mapping 30 ethe 1/1/7
!
vlan 30 by port
untagged ethe 1/1/9 to 1/1/10
no spanning-tree
pvlan type community
!
...
some lines omitted for brevity...
Syntax: copy flash console filename
For filename, enter the name of a file stored in flash memory.
Using SNMP to upgrade software
You can use a third-party SNMP management application such as HP OpenView to upgrade software
on a Brocade device.
Using SNMP to upgrade software
96 FastIron Ethernet Switch Administration Guide
53-1003625-01

Brocade Communications Systems FastIron Specifications

General

Brand	Brocade Communications Systems
Model	FastIron
Category	Switch
Language	English