Resetting LLDP statistics
To reset LLDP statistics, enter the clear lldp statistics command at the Global CONFIG level of the
CLI. The Brocade device will clear the global and per-port LLDP neighbor statistics on the device (refer
to Displaying LLDP statistics on page 210).
device#clear lldp statistics
Syntax: clear lldp statistics [ ports ethernet port-list | all ]
If you do not specify any ports or use the keyword all , by default, the system will clear lldp statistics on
all ports.
Clearing cached LLDP neighbor information
The Brocade device clears cached LLDP neighbor information after a port becomes disabled and the
LLDP neighbor information ages out. However, if a port is disabled then re-enabled before the neighbor
information ages out, the device will clear the cached LLDP neighbor information when the port is re-
enabled.
If desired, you can manually clear the cache. For example, to clear the cached LLDP neighbor
information for port e 20, enter the following command at the Global CONFIG level of the CLI.
device#clear lldp neighbors ports e 20
Syntax: clear lldp neighbors [ ports ethernet port-list | all ]
If you do not specify any ports or use the keyword all , by default, the system will clear the cached
LLDP neighbor information for all ports.
Resetting LLDP statistics
FastIron Ethernet Switch Administration Guide 215
53-1003625-01
To Next Page
Loading...
