Displaying SNMP Information
This section lists the commands for viewing SNMP-related information.
Displaying the Engine ID
To display the engine ID of a management module, enter a command such as the following.
device#show snmp engineid
Local SNMP Engine ID: 800007c70300e05290ab60
Engine Boots: 3
Engine time: 5
Syntax: show snmp engineid
The engine ID identifies the source or destination of the packet.
The engine boots represents the number of times that the SNMP engine reinitialized itself with the same
engine ID. If the engineID is modified, the boot count is reset to 0.
The engine time represents the current time with the SNMP agent.
Displaying SNMP groups
To display the definition of an SNMP group, enter a command such as the following.
device#show snmp group
groupname = exceptifgrp
security model = v3
security level = authNoPriv
ACL id = 0
IPv6 ACL name: ipv6acl
readview = exceptif
writeview =
none
Syntax: show snmp group
The value for security level can be one of the following.
Security level Authentication
none If the security model shows v1 or v2, then security level is blank. User names are not used to
authenticate users; community strings are used instead.
noauthNoPriv Displays if the security model shows v3 and user authentication is by user name only.
authNoPriv Displays if the security model shows v3 and user authentication is by user name and the MD5 or
SHA algorithm.
Displaying user information
To display the definition of an SNMP user account, enter a command such as the following.
device#show snmp user
Displaying SNMP Information
FastIron Ethernet Switch Administration Guide 159
53-1003625-01
To Next Page
Loading...
Need help?
General
