Brocade Communications Systems FastIron - Displaying Information for Breakout Ports

device# Flash Memory Write (8192 bytes per dot) .
Copy Done.
Displaying information for breakout ports
Use the show breakout command to display breakout port status.
The show breakout command indicates which ports are configured for breakout and which breakout
ports are in operation. The command also displays ports that have been configured for breakout but that
are not yet broken out into sub-ports, pending reload.
The following example displays breakout port information for an ICX 7750-48F.
Port 1/2/1 is the only port with active sub-ports; however, ports 1/2/2 and 1/2/4
are configured for breakout, pending reload.
Device# show breakout
Unit-Id: 1
Port Module Exist Module Conf Breakout-config Breakout-oper
1/2/1 yes no yes yes
1/2/2 yes no yes no
1/2/3 yes no no no
1/2/4 yes no yes no
1/2/5 yes no no no
1/2/6 yes no no no
1/3/1 yes no no no
1/3/2 yes no no no
1/3/3 yes no no no
1/3/4 yes no no no
1/3/5 yes no no no
1/3/6 yes no no no
Displaying information for breakout ports
FastIron Ethernet Switch Administration Guide 383
53-1003625-01