The vrf-name parameter must specify the name of a pre-configured VRF. If the VRF is not pre-
configured, command execution fails, and the following error message is displayed.
Error - VRF <vrf-name>
doesn't exist
When the management VRF is configured, the following Syslog message is displayed.
SYSLOG: VRF <vrf-name>
has been configured as management-vrf
Enter the no form of the command to remove the management VRF. When the management VRF is
deleted, the following Syslog message is displayed.
SYSLOG: VRF <vrf-name>
has been un-configured as management-vrf
Configuration notes
Consider the following configuration notes:
• If a management VRF is already configured, you must remove the existing management VRF
configuration before configuring a new one. If not, the system displays the following error message.
device(config)# management-vrf red
Error - VRF mvrf already configured as management-vrf
• If you try to delete a management VRF that was not configured, the system displays the following
error message.
device(config)# no management-vrf red
Error - VRF red is not the current management-vrf
• If a VRF is currently configured as the management VRF, it cannot be deleted or modified.
Attempting to do so causes the system to return the following error message.
device(config)# no vrf mvrf
Error - Cannot modify/delete a VRF which is configured as management-vrf
Displaying management VRF information
To display IP Information for a specified VRF, enter the following command at any level of the CLI.
device(config)# show vrf mvrf
VRF mvrf, default RD 1100:1100, Table ID 11
Configured as management-vrf
IP Router-Id: 1.0.0.1
Interfaces:
ve3300 ve3400
Address Family IPv4
Max Routes: 641
Number of Unicast Routes: 2
Address Family IPv6
Max Routes: 64
Number of Unicast Routes: 2
Syntax: show vrf vrf-name
The vrf-name parameter specifies the VRF for which you want to display IP information.
Configuration notes
FastIron Ethernet Switch Administration Guide 25
53-1003625-01
To Next Page
Loading...
Need help?
General
