show vrf output descriptionsTABLE 2
This field Displays
VRF vrf-name The name of the VRF.
default RD The default route distinguisher for the VRF.
Table ID The table ID for the VRF.
Routes The total number of IPv4 and IPv6 Unicast routes configured on this VRF.
Configured as management-vrf Indicates that the specified VRF is configured as a management VRF.
IP Router-Id The 32-bit number that uniquely identifies the router.
Number of Unicast Routes The number of Unicast routes configured on this VRF.
The show who command displays information about the management VRF from which the Telnet or
SSH connection has been established.
device(config)# show who
Console connections:
established, monitor enabled, privilege super-user, in config mode
1 minutes 47 seconds in idle
Telnet server status: Enabled
Telnet connections (inbound):
1 established, client ip address 10.53.1.181, user is lab, privilege super-user
using vrf default-vrf.
2 minutes 46 seconds in idle
2 established, client ip address 10.20.20.2, user is lab, privilege super-user
using vrf mvrf.
16 seconds in idle
3 closed
4 closed
5 closed
Telnet connections (outbound):
6 established, server ip address 10.20.20.2, from Telnet session 2, ,
privilege super-user
using vrf mvrf.
12 seconds in idle
7 closed
8 closed
9 closed
10 closed
SSH server status: Enabled
SSH connections:
1 established, client ip address 10.53.1.181, privilege super-user
using vrf default-vrf.
you are connecting to this session
3 seconds in idle
2 established, client ip address 10.20.20.2, privilege super-user
using vrf mvrf.
48 seconds in idle
3 closed
4 closed
5 closed
6 closed
7 closed
8 closed
9 closed
10 closed
11 closed
12 closed
13 closed
14 closed
15 closed
16 closed
Management Applications
26 FastIron Ethernet Switch Administration Guide
53-1003625-01
To Next Page
Loading...
Need help?
General
