Syntax: show who
To display packet and session rejection statistics due to failure in management VRF validation, enter
the following command.
device(config)# show management-vrf
Management VRF name : sflow
Management Application Rx Drop Pkts Tx Drop Pkts
SNMP Engine 0 11
RADIUS Client 0 0
TFTP Client 0 0
Traps - 0
SysLogs - 0
TCP Connection rejects:
Telnet : 0
SSH (Strict): 685
TACACS+ Client : 0
Syntax: show management-vrf
show management-vrf output descriptionsTABLE 3
This field Displays
Management VRF name Displays the configured management VRF name.
Management Application Displays the management application names.
Rx Drop Pkts Displays the number of packets dropped in the inbound traffic.
Tx Drop Pkts Displays the number of packets dropped in the outbound traffic.
TCP Connection rejects Displays the number of TCP connections per application rejected due to management
VRF validation.
Make sure that the management VRF is configured before executing the show management-vrf
command. If not, the system displays the following error message.
Error - Management VRF is not configured.
To clear the management VRF rejection statistics, enter the following command.
device(config)# clear management-vrf-stats
Syntax: clear management-vrf-stats
Management Applications
FastIron Ethernet Switch Administration Guide 27
53-1003625-01
To Next Page
Loading...
Need help?
General
