Example civic address location advertisement
The Civic address location advertisement will appear similar to the following on the remote device, and
in the CLI display output on the Brocade device (show lldp local-info) .
+ MED Location ID
Data Format: Civic Address
Location of: Client
Country : "US"
CA Type : 1
CA Value : "CA"
CA Type : 3
CA Value : "Santa Clara"
CA Type : 6
CA Value : "4980 Great America Pkwy."
CA Type : 24
CA Value : "95054"
CA Type : 27
CA Value : "5"
CA Type : 28
CA Value : "551"
CA Type : 29
CA Value : "office"
CA Type : 23
CA Value : "John Doe"
Configuring emergency call service
The Emergency Call Service (ECS) location is used specifically for Emergency Call Services
applications.
When you configure a media Endpoint location using the emergency call services location, you specify
the Emergency Location Identification Number (ELIN) from the North America Numbering Plan format,
supplied to the Public Safety Answering Point (PSAP) for ECS purposes.
To configure an ECS-based location for LLDP-MED, enter a command such as the following at the
Global CONFIG level of the CLI.
device(config)#lldp med location-id ecs-elin 4082071700
Syntax: [no] lldp med location-id ecs-elin number ports ethernet port-list | all
number is a number from 10 to 25 digits in length.
Example ECS ELIN location advertisements
The ECS ELIN location advertisement will appear similar to the following on the remote device, and in
the CLI display output on the Brocade device (show lldp local-info ).
+ MED Location ID
Data Format: ECS ELIN
Value : 4082071700
Defining an LLDP-MED network policy
An LLDP-MED network policy defines an Endpoint VLAN configuration (VLAN type and VLAN ID) and
associated Layer 2 and Layer 3 priorities that apply to a specific set of applications on a port.
Configuring emergency call service
204 FastIron Ethernet Switch Administration Guide
53-1003625-01
To Next Page
Loading...
Need help?
General
