EasyManuals Logo

Brocade Communications Systems FastIron User Manual

Brocade Communications Systems FastIron
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
NOTE
The SNMP source interface configuration command snmp-server trap-source must be compatible
with the management VRF configuration.
SSH server
When the management VRF is configured, the incoming SSH connection requests are allowed only
from the ports belonging to the management VRF and from the out-of-band management port.
Management VRF enforcement occurs only while a connection is established.
To allow the incoming SSH connection requests only from the management VRF and not from the out-
of-band management port, enter the following command.
device(config)# ip ssh strict-management-vrf
The ip ssh strict-management-vrf command is applicable only when the management VRF is
configured. If not, the command issues the following warning message.
Warning - Management-vrf is not configured.
For the SSH server, changing the management VRF configuration or configuring the ip ssh strict-
management-vrf command does not affect the existing SSH connections. The changes are be applied
only to new incoming connection requests.
Telnet client
When the VRF name is specified in the telnet vrf command, the Telnet client initiates Telnet requests
only from the ports belonging to the specified VRF.
To configure the VRF name in outbound Telnet sessions, enter the following command at the privileged
EXEC level.
device(config)# telnet vrf red 10.157.22.39
Syntax: telnet vrf vrf-name IPv4address | ipv6 IPv6address
The vrf-name variable specifies the name of the pre-configured VRF.
RADIUS client
When the management VRF is configured, the RADIUS client sends RADIUS requests or receives
responses only through the ports belonging to the management VRF and through the out-of-band
management port.
Any change in the management VRF configuration takes effect immediately for the RADIUS client.
NOTE
The RADIUS source interface configuration command ip radius source-interface must be compatible
with the management VRF configuration.
SSH server
FastIron Ethernet Switch Administration Guide 23
53-1003625-01

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron and is the answer not in the manual?

Brocade Communications Systems FastIron Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron
CategorySwitch
LanguageEnglish

Related product manuals