sFlow information TABLE 37
Parameter Definition
sFlow version The version of sFlow enabled on the device, which can be one of the following:
• 2
• 5
sFlow services The feature state, which can be one of the following:
• disabled
• enabled
sFlow agent IP address The IP address that sFlow is using in the agent_address field of packets sent to the
collectors. Refer to sFlow and agent address on page 247.
sFlow source IP address The IPv4 address that sFlow is using as the source IP address in the sFlow datagram.
sFlow source IPv6
address
The IPv6 address that sFlow is using as the source IP address in the sFlow datagram.
Collector The collector information. The following information is displayed for each collector:
• IP address
• UDP port
If more than one collector is configured, the line above the collectors indicates how
many have been configured.
Configured UDP source
port
The UDP source port used to send data to the collector.
Polling interval The port counter polling interval.
Configured default
sampling rate
The configured global sampling rate. If you changed the global sampling rate, the value
you entered is shown here. The actual rate calculated by the software based on the
value you entered is listed on the next line, "Actual default sampling rate".
Actual default sampling
rate
The actual default sampling rate.
Sample mode Indicates whether only the non-dropped packets or all the packets, including the
dropped packets, are included for sFlow sampling.
The maximum sFlow
sample size
The maximum size of a flow sample sent to the sFlow collector.
exporting cpu-traffic Indicates whether or not the sFlow agent is configured to export data destined to the
CPU (e.g., Telnet sessions) to the sFlow collector:
• enabled
• disabled
Network Monitoring
FastIron Ethernet Switch Administration Guide 261
53-1003625-01
To Next Page
Loading...
Need help?
General
