NTP status command output descriptions (Continued)TABLE 4
Field Description
peer dispersion Dispersion of root path.
system poll interval Poll interval of the local system.
last update Time the router last updated its NTP information.
server mode Status of the NTP server mode for this device.
client mode Status of the NTP client mode for this device.
master Status of the master mode.
master stratum Stratum number that will be used by this device when master is enabled and no upstream
time servers are accessible.
panic mode Status of the panic mode.
Displaying NTP associations
Use the show ntp associations command to display detailed association information of the NTP
server or peers.
Brocade# show ntp associations
address ref clock st when poll reach delay offset disp
*~172.19.69.1 172.24.114.33 3 25 64 3 2.89 0.234 39377
~2001:235::234
INIT 16 - 64 0 0.00 0.000 15937
* synced, # selected, + candidate, - outlayer, x falseticker, ~ configured
The following table provides descriptions of the show ntp associations command output.
NTP associations command output descriptionsTABLE 5
Field Description
* The peer has been declared the system peer and lends its variables to the system variables.
# This peer is a survivor in the selection algorithm.
+ This peer is a candidate in the combine algorithm.
- This peer is discarded as outlier in the clustering algorithm.
x This peer is discarded as 'falseticker' in the selection algorithm.
~ The server or peer is statically configured.
address IPv4 or IPv6 address of the peer.
ref clock IPv4 address or first 32 bits of the MD5 hash of the IPv6 address of the peer to which clock is
synchronized.
Displaying NTP associations
FastIron Ethernet Switch Administration Guide 49
53-1003625-01
To Next Page
Loading...
Need help?
General
