EasyManuals Logo

Brocade Communications Systems FastIron User Manual

Brocade Communications Systems FastIron
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
1/1/47 Up Forward Full 1G None No 1 0 748e.f82d.7a2e
mgmt1 Up None Full 1G None No None 0 748e.f82d.7a00
In this output, the port name for inteface 1/1/23 is truncated.
Use the show interface brief wide command to avoid truncating long port names.
To display the complete port name for an interface, enter the following command.
Brocade# show interface brief wide
Port Link State Dupl Speed Trunk Tag Pvid Pri
MAC Name
1/1/23 Up Forward Full 1G None No 1 0 748e.f82d.7a16 connected-
to-the nearest device
1/1/47 Up Forward Full 1G None No 1 0 748e.f82d.7a2e
mgmt1 Up None Full 1G None No None 0 748e.f82d.7a00
Syntax: show interface brief [ wide ] [ ethernet stack-unit/slot/port | loopback port | management
port | slot port | tunnel port | ve port ]
The ethernet stack-unit/slot/port parameter specifies the Ethernet port for which you want to display the
interface information.
The loopback option specifies the loopback port for which you want to display the interface information.
The management option specifies the management port for which you want to display the interface
information.
The slot option specifies all the ports in a slot for which you want to display the interface information.
The tunnel option specifies the tunnel port for which you want to display the interface information.
The ve option specifies the virtual routing (VE) port for which you want to display the interface
information.
The following table describes the output parameters of the show interface brief wide command.
Output parameters of the show interface brief wide commandTABLE 7
Field Description
Port Specifies the port number.
Link Specifies the link state.
Port-State Specifies the current port state.
Speed Specifies the link speed.
Tag Specifies if the port is tagged or not.
Pvid Specifies the port VLAN ID.
Pri Specifies the priority.
MAC Specifies the MAC address.
Name Specifies the port name.
To display the complete port name for an Ethernet interface, enter a command such as the following.
Brocade# show interface brief wide ethernet 1/1/23
Basic Software Features
FastIron Ethernet Switch Administration Guide 57
53-1003625-01

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron and is the answer not in the manual?

Brocade Communications Systems FastIron Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron
CategorySwitch
LanguageEnglish

Related product manuals