Brocade Communications Systems FastIron User Manual

sysmon pp error-count ..................................................................... 276
clear sysmon counters ..................................................................... 276
show sysmon logs ............................................................................278
show sysmon counters .....................................................................278
show sysmon config .........................................................................282
show sysmon system sfm ................................................................ 283
Syslog.................................................................................................................................. 285
About Syslog messages................................................................................285
Displaying Syslog messages........................................................................ 286
Enabling real-time display of Syslog messages................................286
Enabling real-time display for a Telnet or SSH session.................... 286
Displaying real-time Syslog messages ............................................ 287
Syslog service configuration......................................................................... 287
Displaying the Syslog configuration.................................................. 287
Disabling or re-enabling Syslog........................................................ 290
Specifying a Syslog server................................................................291
Specifying an additional Syslog server............................................. 291
Disabling logging of a message level................................................291
Changing the number of entries the local buffer can hold.................291
Changing the log facility.................................................................... 292
Displaying interface names in Syslog messages.............................. 293
Displaying TCP or UDP port numbers in Syslog messages............. 293
Retaining Syslog messages after a soft reboot.................................293
Clearing the Syslog messages from the local buffer.........................294
Syslog messages for hardware errors.............................................. 294
Syslog messages.................................................................................................................. 297
Brocade Syslog messages............................................................................297
Power over Ethernet ............................................................................................................. 339
Power over Ethernet overview...................................................................... 339
Power over Ethernet terms used in this chapter............................... 339
Methods for delivering Power over Ethernet..................................... 340
PoE autodiscovery............................................................................ 342
Power class.......................................................................................342
Dynamic upgrade of PoE power supplies......................................... 344
Power over Ethernet cabling requirements....................................... 345
Supported powered devices..............................................................346
Installing PoE firmware .................................................................... 346
PoE and CPU utilization....................................................................350
Enabling and disabling Power over Ethernet................................................ 351
Disabling support for PoE legacy power-consuming devices....................... 352
Enabling the detection of PoE power requirements advertised through
CDP......................................................................................................... 353
Command syntax for PoE power requirements................................ 353
Setting the maximum power level for a PoE power-consuming device........ 354
Considerations for setting power levels............................................ 354
Configuring power levels command syntax.......................................354
Setting the power class for a PoE power-consuming device........................ 355
Setting the power class command syntax.........................................356
Setting the power budget for a PoE interface module on an FSX device..... 356
Setting the inline power priority for a PoE port .............................................357
Command syntax for setting the inline power priority for a PoE
port.............................................................................................. 357
FastIron Ethernet Switch Administration Guide
9
53-1003625-01

Brocade Communications Systems FastIron Specifications

General

Brand	Brocade Communications Systems
Model	FastIron
Category	Switch
Language	English