EasyManuals Logo

Brocade Communications Systems NetIron MLXe Series User Manual

Brocade Communications Systems NetIron MLXe Series
305 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #193 background imageLoading...
Page #193 background image
Connecting a Router to a Network Device
• Assigning permanent passwords.............................................................................................................................................................193
• Conguring IP addresses............................................................................................................................................................................194
• Understanding management port functions.......................................................................................................................................196
• Connecting the router to a network device.......................................................................................................................................... 197
• Testing network connectivity......................................................................................................................................................................200
Assigning permanent passwords
DANGER
The procedures in this manual are for qualied service personnel.
By default, the CLI is not protected by passwords. To secure CLI access, it is strongly recommended that you assign passwords.
The CLI contains the following access levels:
• Privileged EXEC - This level is also called the Enable level and can be secured by a password. From this level you can manage
les on the management module ash memory or a auxiliary ash card in the management module slots 1 or 2, save the
system conguration to ash memory, and clear caches.
• CONFIG - The conguration level. From this level you can congure a system IP address and congure routing features. To
access the CONFIG mode, you must already be logged into the Privileged level of the EXEC mode.
NOTE
You cannot assign a password using the Web management interface. You can assign passwords using the Brocade Network
Advisor software if an Enable password for a super user is already congured on the device.
You can set the following levels of Enable passwords:
• Super user - Allows complete read-and-write access to the system. This is generally for system administrators and is the only
password level that allows you to congure passwords.
NOTE
You must set a super-user password before you can set other types of passwords.
• Port conguration - Allows read-and-write access for specic ports but not for global (system-wide) parameters.
• Read only - Allows access to the Privileged EXEC mode and CONFIG mode but only with read access.
To set passwords, perform the following steps:
1. At the opening CLI prompt, enter enable to change to the Privileged level of the EXEC mode.
device enable
device#
2. Access the CONFIG level of the CLI by entering the congure terminal command.
device# configure terminal
device(config)#
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04 193

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems NetIron MLXe Series and is the answer not in the manual?

Brocade Communications Systems NetIron MLXe Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelNetIron MLXe Series
CategoryNetwork Router
LanguageEnglish

Related product manuals