Brocade Communications Systems NetIron MLXe Series - Port Specifications for All Router Models; 2 x100 GbE CFP2 Dynamic Port Configuration

Electromagnetic approvals
• FCC Part 15, Subpart B (Class A)
• EN 55022 (CE mark) (Class A)
• EN 55024 (CE mark) (Immunity) for Information Technology Equipment
• ICES-003 (Canada) (Class A)
• AS/NZ 55022 (Australia) (Class A)
• VCCI (Japan) (Class A)
• EN 61000-3-2
• EN 61000-3-3
• EN 61000-6-1
Port
specications for all router models
This section describes port specications for all router models.
2x100GbE CFP2 Dynamic Port Conguration
The dynamic port conguration is shown for the 2x100GbE CFP2 based high density blade chassis.
Dynamic port conguration for the 20x10/1GbE based high density blade chassis is shown in the following table.
TABLE 54 20x10/1GbE Module Dynamic Port
Conguration
# Ports Line Speed SFP Type Conguration Status Port Speed Status
20 1GbE SFP 1GbE Supported
10GbE SFP+ 10GbE Supported
10GbE SFP 10GbE Not Supported
1GbE SFP+ 1GbE Not Supported
10GbE SFP+ 1GbE Not Supported
Console port pin assignments
The console port is a standard male DB-9 connector, as shown in the following gure. For information about how you can use this port,
refer to Console port on page 31.
FIGURE 124 Console port pin and signaling details
Port specications for all router models
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04 275