NOTE
The management, interface, and switch fabric modules are dedicated, which means that you must install them in Brocade
routers only. If you install these modules in another Brocade device or you install a module intended for another Brocade
device in a Brocade router, the device and modules will not function properly.
Replacing a management module
For instructions on how to install or replace modules, refer to the module installation section in the installation chapter for your router
model.
Installing the Compact Flash Card in an MR2 management module
MR2 management modules allow users to insert an additional 2 Gbps compact ash card. To install the card, you need a at head or
Philips screw driver. Refer to the following gure to see where the slot card should be placed.
NOTE
MR and MR2 management modules should not be used together in the same chassis.Please read the Hardware Installation
Notes that came with your hardware before installing the MR2 management module.The internal compact ash card cannot be
accessed for removal or replacement.To obtain a replacement or a new compact ash card, contact Brocade technical support.
To install a compact ash card in an MR2 management module:
1. Remove the two screws holding the compact ash card cover in place using a at head or Phillips screw driver.
Put the screws and cover plate aside; you will need to reattach the cover using the screws after installing the card.
2. Slide the compact ash card into the slot.
Replacing a management module
Brocade NetIron MLXe Series Hardware Installation Guide
246 53-1004203-04
To Next Page
Loading...
Need help?
General
