Brocade Communications Systems NetIron MLXe Series User Manual

Trac Manager XPP link monitoring
Trac Manager (TM) XPP link status is checked during the line card boot up time. MP will attempt to recover TM XPP link errors by
executing resets and then keeping reset cards down that fail to recover after 3 resets.
Thus TM-XPP link is monitored at boot-up, and recovery action is performed. This check will be placed in periodic TM XPP link
monitoring to catch link issues at run time and perform appropriate recovery.
This feature is supported for the following line cards:
• 8x10GbE
• 20x10-GbE/1GBE (M) / FRU# 53-1003238-xx
• 20x10-GbE/1GbE (X2) / FRU# 53-1003275-xx
• 24x10GbE
• 4x40GbE
• 2x100GbE
Enabling TM-XPP link monitoring
To enable TM XPP link monitoring, enter the sysmon tm nif-check command as shown in the following section.
sysmon tm nif-check
Syntax
sysmon tm nif-check threshold count polling period
[no] sysmon tm nif-check threshold count polling period
Two recovery actions are possible which are listed below:
sysmon tmnif-check action disable-ports
NOTE
disable-ports is default action.
[no] sysmon tmnif-check actionreset-linecard
Parameters
count
Number of link error events occurred within this polling period.
polling period
Period for polling.
Trac Manager XPP link monitoring
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04 227

Brocade Communications Systems NetIron MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	NetIron MLXe Series
Category	Network Router
Language	English