Brocade Communications Systems NetIron MLXe Series User Manual

Examples
To congure the IPv6 ND proxy static route by specifying the destination prex and the outgoing interface:
NOTE
As per the topology mentioned in the packet ow, if the IPv6 ND proxy is congured on R2, then this static route can
be congured on R1 with the destination prex being 2002::/64. The static route can also be congured with
outgoing interface as ve, such as ve 10.
R1(config)#
R1(config)# ipv6 route 2002::/64 ethernet 1/1
R1(config)#
R1(config)# ipv6 route 2003::/64 ve 10
R1(config)# vrf green
R1(config-vrf-green)# address-family ipv6
R1(config-vrf-green-ipv6)# ipv6 route 2002::/64 eth 1/1
R1(config)#vrf green
R1(config-vrf-green)# address-family ipv6
R1(config-vrf-green-ipv6)# ipv6 route 2003::/64 ve 10
To show the
running-cong (with truncated output showing only the static route):
R1(config)# ipv6 route 2002::/64 ethernet 1/1
R1(config)# ipv6 route 2003::/64 ve 10
vrf green
rd 66:66
address-family ipv6
ipv6 route 2002::/64 ethernet 1/1
ipv6 route 2003::/64 ve 10
R1(config)#exit-vrf
DRBG Health Test on IPsec LP
Deterministic Random Bit Generator (DRBG) health and error checks are performed on the IPsec line card used in MLXe.
The FIPS self-test is executed at system startup, which includes DRBG health and error checks. This startup test executes a known
answer test, which includes DRBG health and error checks.
DRBG tests are performed on demand by the user by using the following CLI command:
fips crypto drbg
The expected result is the test is passed. In the event of failure, the system will restart, and perform the test again as part of FIPS self-
tests executed at system startup.
The DRBG Known Answer Test (KAT) and health test are performed during:
• System boot-up and at regular intervals.
• On-demand and periodic testing after 2^24 uses, during instantiate and reseed.
• DRBG check immediately after powering on the system.
The type of DRBG mechanism and the cryptographic primitives used (e.g., AES-128 or SHA-256), are as follows:
• Type of DRBG mechanism: Hash Based
• Cryptographic primitives used: SHA-256
Security strengths of the cryptographic algorithms supported by the implementation: 256
DRBG Health Test on IPsec LP
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04 243

Brocade Communications Systems NetIron MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	NetIron MLXe Series
Category	Network Router
Language	English