The implementation of this feature (e.g., prediction resistance, personalization string, additional input) are as follows:
• Prediction Resistance is not TRUE.
• Personalization String Length = 0
• Additional Input Length = 0
NOTE
The DRBG mechanism functions are not distributed. CTR_DRBG is not used. The code used to perform the DRBG Health Test
on IPSec line card is from OpenSSL FIPS2.05.
Example CLI
DRBG functions can be tested on a demand basis, using CLI commands, by independent requests as shown in the following CLI
example.
fips crypto drbg
LP-1#fips crypto drbg
Initializing Hash based sha-256 drng
Instantiating drbg
Running self tests on drbg
DRBG SHA256 test started
DRBG SHA256 test OK
FIPS CRYPTO: DRBG test PASSED
LP-1#fips crypto force-failure drbg
LP-1#fips crypto drbg
Initializing Hash based sha-256 drng
Instantiating drbg
Running self tests on drbg
DRBG SHA256 test failure induced
DRBG SHA256 test failed as expected
FIPS CRYPTO: DRBG test failed as expected
Aug 20 13:36:15:C:System: Module in slot 1 is rebooted due to FIPS DRBG KAT failure
Aug 20 13:36:15:N:Module 1 is reset by mgmt (reason: FIPS KAT failure)
Module is dow
NetIron XMR/MLX Boot Monitor Version 5.9.0
Enter 'b' to stop at boot monitor
sent IPC_MSGTYPE_REBOOT to slot 16 (my_slot = 0, ipc_post_rx32_mode = 0)
received IPC_MSGTYPE_REBOOT_ACK from fid d020
get_module_type: board_class = 244
DRBG Health Test on IPsec LP
Brocade NetIron MLXe Series Hardware Installation Guide
244 53-1004203-04
To Next Page
Loading...
Need help?
General
