Brocade Communications Systems NetIron MLXe Series User Manual

6to4_tnl tunnel-id
Species IPv6 to IPv4 tunnel number to be used as next hop.
ipv6_tnl tunnel-id
Species IPv6 tunnel to be used as next hop.
name string
Optional name (ASCII string) assigned to the route
metric
Species a value that the Layer 3 switch uses to compare this route to other static routes in the IPv6 static route table
that have the same destination. The metric applies only to routes that the Layer 3 switch has already placed in the IPv6
static route table. Two or more routes to the same destination with the same metric will load share (as in ECMP load
sharing). The range is from 1 through 16. The default is 1.
distance number
Species an administrative distance. The range is from 1 through 255. The default is 1. This is a value that the Layer 3
switch uses to compare this route with routes from other route sources that have the same destination. By default,
static routes take precedence over routes learned by routing protocols. To choose a dynamic route over a static route,
congure the static route with a higher administrative distance than the dynamic route.
tag
Species a tag value for the route. The route tag can be used for route redistribution to routing protocols by means of
route maps (as in IPv4 static route redistribution).
tag-number
A number from 0 through 4294967295. The default is 0.
Modes
Global conguration mode
VRF conguration mode
Usage Guidelines
The no form of the command removes the IPv6 static route. If the route is named, the no command must be used twice, the
rst time to remove the name and the second time to remove the route.
IPv6 ND Proxy
Brocade NetIron MLXe Series Hardware Installation Guide
242 53-1004203-04

Brocade Communications Systems NetIron MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	NetIron MLXe Series
Category	Network Router
Language	English