Brocade Communications Systems NetIron MLXe Series User Manual

2. To remove the fan tray assembly from the router, push down on the latch release with your thumb, grasp the handle, and pull it
toward you as shown in the following two gures. Pulling the assembly unseats the fan tray assembly connector from a router
connector.
DANGER
Be careful not to accidently insert your ngers into the fan tray while removing it from the chassis. The fan may
still be spinning at a high speed.
FIGURE 113 Replacing the fan assembly in a Brocade MLXe Series 4-slot router
FIGURE 114 Replacing the fan assembly in a Brocade MLXe Series 8-slot router
3. Insert the new fan assembly into the fan slot and push the enclosure in until the faceplate is ush with the router. Pushing the
enclosure in seats the fan connector with the router connector.
4. Tighten the four captive screws to secure the fan to the router.
5. Access the CLI, and enter the show chassis command to verify that the fans are operating normally.
Replacing fan assemblies
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04 261

Brocade Communications Systems NetIron MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	NetIron MLXe Series
Category	Network Router
Language	English