Operation Manual
FT1020G3 Rev 2.4
30
• Fully supervised input (N/O or N/C) via end of line resistor 10KΩ (all modules).
• Outputs can be supervised 24V circuits via end of line resistor 10KΩ (1201) or
relay contacts N/O or N/C (1200, 1202 & 1203).
• On board LED indicators for relays activation.
• Pluggable terminals for easy field wiring terminations.
• Low COM loop current consumption.
1201 and 1203 I/O Units require an external 24Vdc power supply, whilst the1200 and 1202
are powered from the COM Loop. Refer to Technical Datasheet TDS053 for full details on
programming and installation.
All units are programmed using the Addressing Tool 4414 or 4414E, the 1201 requires
24V
DC to be applied for addressing the module. All modules are required to be addressed
in “Advanced Mode” setting on the Addressing Tool. These units must also be configured
with EBLWin ≥ V2.4.x for the FDCIE to recognise them.
1200 – SUB997: Single supervised input / single relay output. Used where a single device
needs to be triggered (output) and a return signal is required to report the action has been
carried out (input), e.g. a sprinkler flow switch. Requires one address on the COM loop.
1201 – SUB983: Four supervised inputs / four supervised voltage outputs. Inputs similar
to 1200 input with supervised voltage outputs. Each voltage output is rated to 1 Amp,
requires external 24V
DC supply from the FDCIE or from external power supply. Requires
one address on the COM loop.
1202 – SUB994: Four supervised inputs / four relay outputs. Due to the latching function
of the used relays, the board doesn’t need external 24V supply. Requires one address on
the COM loop.
1203 – SUB991: Eight non-supervised inputs / Eight relay outputs. Requires external 24V
supply and two addresses on the COM loop.
To Next Page
Loading...
