Brooks firetracker FT1020G3 FDCIE - Software Versions; Table 15 Latest Software Versions for FT1020 G3

Operation Manual
FT1020G3 Rev 2.4
87
Note: If the downloaded S/W version is only a small bug-correction, there is no need
to follow the procedure above. If so, download S/W to one control unit at a time, and
then in the control unit, acknowledge all the ’No contact’ faults.
If the software download carried out with TLON network connected, some Control Units
will not have contact with other Control Units during the downloading, the following faults
may be generated:
FAULT: Control unit nn has no contact with Control Unit
nn, network x
dd-mm-yyyy hh:mm
Since control units with new and old S/W will have different information, there will be
“wrong information” fault massages.
FAULT: Restart control unit nn has wrong information
dd-mm-yyyy hh:mm
The faults should be acknowledged.
Note: In large TLON networks, there might be a large amount of fault massages
generated.
19.4 Software Versions
Due to continual development and improvement, different S/W versions can be found.
The S/W versions listed in Table 15 below were the valid S/W when this document was
written (the date of this document or date of revision).
Table 15 Latest Software Versions for FT1020G3
Software version for: Latest version
Required version
Standard FT1020G3
2.4.4
2.4.4
4580; 8 zones expansion board, PCB no. 9287-2B
1.0.5
1.0.2
4580; 8 zones expansion board, PCB no. 9287-3A
2.0.4
2.0.4
4581; 8 relays expansion board
1.0.2
1.0.2
4582; I/O Matrix board
1.0.4
1.0.2
4583; Inputs and Outputs expansion board
1.0.2
1.0
5090; TLON connection board
1.0.0
1.0.0
1728; Ext. Presentation unit (EPU)
1.5.0
1.4.1
1735 / 1736; Alert Annunciation unit (AAU)
1.5.0
1.4.1
EBLWin
2.4.3
2.4.1
TLON Manager
2.0.1
1.2
1598 Web-server II
2.4.1
2.4.1
Note: The EBLWin version and the EBL system software and web-server software
version must be the same, at least the first two digits; 2.4.x -- 2.4.x.