Operation Manual
FT1020G3 Rev 2.4
33
If a user should have access to the web-server only, it is possible to choose a stronger
password. It consists of 6 to 10 characters and digits as well as letters can be used.
Note: The letters are case sensitive 36 CHANGE PASSWORD (H10).
6.2 Access Levels
To use the keypad in FT1020G3 and get access to the menus, it is necessary to log in with
a user name and a password for level 2A, 2B or 3A.
Before any SSD is downloaded (e.g. in a brand new control unit), only "0" is shown and no
password is required. After SSD download, the downloaded user names and passwords
will be valid.
How to Log On
a) Open the acrylic door with 003 key. Press the soft key Menu.
b) On the keypad, press 0, 1, 2 - - 8 or 9 to select a user. Press
c) Type the password for that user. (Six digits. * * * * * *)
27
After typing a correct password, a main menu list with the available menus will be
displayed. For "0", Information only, no password is required.
NO ACCESS!
No access will be shown if the password was incorrect. Try again.
Note: After three attempts with wrong passwords, the log in function will be blocked for
one hour for the user name respectively.
Navigation / General Procedures
• Scroll in lists or menus with .
• Press to toggle between different choices.
• Press soft key to toggle between different functions.
• Press to select / accept.
• Press the digits on the numeric pad to choose a menu or enter data.
• A successful disablement is indicated by a beep and a "√". It will also be shown in
the Re-enable list.
• A non-successful disablement is indicated by another beep and a "X".
• To leave a menu press ESC.
• To leave the menu system, press the soft key Escape menu.
• To logout, close the door.
Quick jump can be used within each menu, fe.g. press "6" for a quick jump to menu H6.
You will be automatically logged out 15 minutes after the last action, and directly when you
close the door. A new login is then required. If you leave the menu system without closing
the door, you have access to the menu system again only by using the soft key "Menu". A
new login is not required.
27
Default password “000000” for information only, “111111” for building officer and “222222” for service personnel.
To Next Page
Loading...
