Brooks firetracker FT1020G3 FDCIE - User Level; Table 13 Levels of Access; Table 14: Access Levels and User Names

Operation Manual
FT1020G3 Rev 2.4
34
6.3 User Level
Each user level type has access to specific menus according to Table 13.
Table 13 Levels of access
Information only Building Officer Service Personnel
H4 Present system status H1 Perform monthly test H1 Perform monthly test
H6 Display faults H2 Disable or re-enable H2 Disable or re-enable
H9 Interlocking outputs and inputs H3 Set calendar and clock H3 Set calendar and clock
H10
Change password
H4 Present system status H4 Present system status
H6 Fault acknowledge H5 Service
H7 Perform zone test H6 FAULT Acknowledge
H9 Interlocking outputs and inputs H7 Perform zone test
H10 Change password H8 Maintenance
H9 Interlocking outputs and
inputs
H10 Change password
User Level as specified in AS7240.2
The user names and type of access permitted are shown in Table 14.
Table 14: Access Levels and user names
User level
User level type
Required action / equipment
Access to
0 None
None
(Door closed).
View indications and controls
1
Fire service
personnel
Open door (003 key required).
Fire alarm response via fire
brigade section, fan control, hot
buttons zone disablement
2A Information only
003 key + log on as
“Information only”
Same as 1 + keypad.
Menu H4, H6
a)
, H9
b)
& H10
2B Building officer
003 key + log on as “Building
officer”
Same as 2A + keypad.
Menu H1-H4, H6, H7, H9 & H10
3A
Service
personnel
003 key + log on as “Service
personnel”
Same as 2B + keypad.
Menu H1-H10
3B
-
003 Key + PC + EBLWin
SSD & S/W download
4 -
003 Key + PC + EBLWin +
special password
SSD & S/W download + reset of
alarm counter
a) Information only, i.e. the faults cannot be acknowledged.
b) Menu H9/C1 only.
It is recommended to change the default passwords and to add a number of new user
names and passwords. However, these access codes can be changed by typing over the
previous password and reassigning the EBL and/or Web check boxes with the appropriate
access level in the Type field.
Note: Initials are required in system FT1020G3 since they will be used in the event log
instead of the User names. In a new FDCIE (i.e. before any Site Specific Data has been
downloaded), only user "0" is available. No password is required and you have access
to all menus. After download of SSD, the downloaded user names and passwords will
be valid.