Brooks firetracker FT1020G3 FDCIE - Page 97

Operation Manual
FT1020G3 Rev 2.4
95
"

|"
Disable --------------------------------------------------------------
Zone _ _ _ address _ _
Automatic re-enable: No
Re-enable list
(1)
Zone 003 address 01 autom. re-enable at 17:05
Select in the Re-enable
list "▼" (in this example
there is only one item)
and press "
↲
".
Re-enabled zone or
zone / address will
disappear from the list,
indicated with a beep.
Change type
of disablement
"
↲
"
Disable
Zone 000 address 00
Automatic re-enable: No
Disable (or Re-enable)
another Zone, Zone /
Address or press "
ESC".
Change type
of disablement
"ESC"
B1 Zone or Zone/Address
B2 Output
B3 Output type
B4 Alarm devices
B5 Routing equipment
B6 Alert annunciation function
Scroll to another menu
or press "ESC" or
"
Escape menu".
Escape
menu
Note: The sensor values for disabled analogue smoke detectors in NORMAL mode will
not be used for calculation of the week average sensor value, i.e. only the values saved
before and after the disablement will be used for this calculation.