2-18
Confidential
Error
Codes
Description
Refer
to:
Error
Codes
Description
Refer
to:
8703 *1 8F01 *1
8708 *1 8F02 *1
8709 *1 8F03 *1
870A *1 9001 *1
870B *1 9002
The size of paper loaded in the T1
and the one specified from the driver
are not same when printing from the
T1.
2-72
870C *1 9003 *1
870D *1 9004 *1
870E *1 9005 *1
870F *1 9006 *1
8801 *1 9102 *1
8802 *1 9103 *1
8808 *1 9104 *1
8809 *1 9105 *1
880A *1
9200 *1
9201 *1
8901 *1 9202
When printing from the T1, paper type
setting in the machine does not match
the setting in the driver.
2-72
8902 *1 9203 *1
8903
The back cover sensor detected the
open state when 2-sided printing is
started (before the registration of
printing in the engine).
2-70 9204 *1
8904
The back cover sensor detected the
open state during 2-sided printing
(after the registration of printing in the
engine).
2-70 9205 *1
8A01
The registration rear sensor detected
that the fed paper was larger or
smaller than the specified size in 2-
sided printing.
2-71 9206 *1
8A02 *1 9301 *1
8B01 *1 9302
When printing from the T1, the T1
paper feed sensor detected that no
paper was in the T1.
2-73
8C00
There is no paper in the manual feed
slot when printing from the manual
feed slot.
2-71
9303 *1
8D01
The registration rear sensor detected
that the paper loaded in the T1 was
smaller than the specified size.
2-71 9304 *1
8D02
The paper size indicated for printing
data while the back cover is closed
was under the specified value.
2-72 9305 *1
8E01 *1 9306 *1
8E02 *1 9309 *1
To Next Page
Loading...
