5-139
Confidential
■ CIS model
9.10.9
Scanner Unit
(1) Remove the cup S M3x6 Taptite screw, and remove the FB FG harness.
(2) Disconnect the Connector of the Scanner motor harness from the Driver PCB.
(3) Disconnect the two Connectors and the FFC from the Main PCB.
Fig. 5-161
Note:
• In the case of the CCD model, refer to "9.10.1 Scanner Unit ASSY" to "9.10.8 Home
Position Sensor".
Note:
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
Driver PCB
Driver PCB
Scanner motor harness
FFC
FB FG harness
Panel PCB harness
Home position sensor harness
Main PCB
Main PCB
<Left side>
Taptite cup S M3x6
To Next Page
Loading...
