Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 31
Electronic card – 5710
Warning Codes without registration
Accelerator, R1
1. Check that the accelerator has not stuck in the actuated posi-
tion.
2. Check that R1 is located in its bracket.
Check that there is no play or oxidisation on the connector
pins on terminal X19. The voltage on input 501 should be
3.7 +/- 0.2 VDC when R1 is correctly mechanically adjusted.
3. For calibration of the speed control, see the section “Parame-
ter setting” in this manual.
(Deactuated position).
4. If the voltage on input 501 is correct and calibration does not
rectify the problem, then replace the A5 electronic card.
Code 16
Description Voltage from accelerator pedal’s potentiometer R1 is
outside the calibrated value at start up. (+/-0.2V).
Error mode Start up error
Error cause 1. Activated pedal at start up
2. Faulty potentiometer/bracket/wiring
3. Calibration error.
4. Defective electronic card A5
Comments Manoeuvre to neutral position
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...