Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 35
Electronic card – 5710
Warning Codes without registration
Tilt control, joystick R13
1. Check that the joystick for the tilt operation has not stuck in an
actuated position.
2. Check that R13 is located in its bracket.
Check that there is no play or oxidisation on the connector
pins on terminal X11. The voltage on input 505 should be 3.7 +/
-0.6 VDC when R13 is correctly adjusted.
3. Calibration of the tilt control.
- Check that the joystick is not actuated and is in its neutral posi-
tion.
- Restart the truck
4. Calibration of the joystick now takes place. If the correct volt-
age is on input 505 and calibration does not help, replace the
A5 electronic card.
Code 22
Description Potentiometer R13 for tilting gives incorrect voltage
when ignition is switched on (+/-0.6 V).
Error mode Start up error
Error cause 1. Activated joystick at start up
2. Faulty potentiometer/wiring
3. Calibration error
4. Defective electronic card A5
Comments
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...