Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 37
Electronic card – 5710
Warning Codes without registration
4. Calibration of the joystick now takes place. If the correct volt-
age is on input 504 and calibration does not help, replace the
A5 electronic card.
Extra hydraulic functions, joystick R14 and joystick R15
1. Check that both of the joysticks for the extra hydraulic func-
tions have not stuck in actuated positions.
2. Check that R14 and R15 are located in their brackets.
Check that there is no play or oxidisation on the connector
pins on terminal X11. The voltage on input 506 and 510 should
be 3.7 +/-0.6 VDC when R14 and R15 are correctly adjusted.
3. Calibration of the control for extra hydraulic functions
- Check that both the joysticks are not actuated and are in their
neutral positions.
- Restart the truck.
4. Calibration of the joysticks now takes place. If the correct volt-
age is on inputs 506 and 510 and calibration does not help, re-
place the A5 electronic card.
Code 24
Description Potentiometer R14 or R15 for extra functions “1“ and
“2“ give incorrect voltage when the ignition key is
switched on (+/-06 V).
Error mode Start up error
Error cause 1. Activated joystick at start up
2. Faulty potentiometer/wiring
3. Calibration error
4. Defective electronic card A5
Comments Manoeuvre to neutral position
82
83
85
86
81
98
100
84
ELECTRONIC CARD
A5
505
506
510
202
208
204
205
301
503
504
X
X
X
INP. JOYSTICK FORK
INP. JOYSTICK REACH CARRIAGE
INP. JOYSTICK TILT
INP. JOYSTICK SPARE 1
INP. JOYSTICK SPARE 2
INP. WEIGHT
INP. OVERRIDE
INP. LIFT LIMIT SPECIAL HEIGHT
X33
X33
X11
X11
Ye
Ye
R
R
Gr
Gr
R14
R15
X11
X11
X32
X32
28
27
Pg 6 4
Pg 6 4
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...