Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 39
Electronic card – 5710
Warning Codes without registration
Battery measurement
1. Check the voltage supply (+48 VDC) to the battery indicator,
cable 70 feeds positive to terminal 601 and cable 71 feeds ter
-
minal 602 with negative.
2. Check that cable 72 and its connector are intact and make
good contact from the shunt to terminal 603. Also check that
cable 71 makes good contact with the shunt.
3. If there is no error as set out in points 1 and 2, try a new A5
card.
4. Contact the battery manufacturer for assistance in determin-
ing whether the battery is OK.
Code 27
Description Incorrect battery measurement
Error mode Battery display flashes
Error cause 1. No voltage to the battery indicator
2. Poor contact on battery measurement cables
3. Defective electronic card A5
4. Defective battery
Comments
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...