T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
24- 46 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Electronic card – 5710
Warning Codes without registration
Pump motor's pulse transducer bearing, U12
1. Check the cables to U12.
- Remove connection X13.
- Check that cable 16 is intact between X13 and terminal 4 on A1.
- Check that cable 15 is intact between X13 and terminal 3 on A1.
- Check that cable 17 is intact between X13 and terminal 5 on A1.
- Check that cable 18 is intact between X13 and terminal 6 on A1.
- Also check the connector pins on the terminals for play and oxidi-
sation.
- If the cables are okay, replace the transducer bearing U12.
2. If the fault remains, replace A2.
Code 48
Description Incorrect number of pulses from the pump motor's
pulse transducer bearing
Error mode General error
Error cause 1. Faulty sensor/wiring
2. Defective drive regulator
Comments
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...