Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 89
Electronic card – 5710
Error Codes
1. Replace the drive regulator, A1..
Temperature sensor B1 in drive motor M1
1. Check that the ventilation is okay, especially the fan M10 in the
motor compartment.
2. Check B1.
- Remove connection X26. Measure B1 in X26 with the ohmmeter,
approx. 570 ohm at 20
o
C.
- Check that cable 11 is intact between X26 and terminal 4 on A1.
- Check that cable 14 is intact between X26 and terminal 7 on A1.
- Also check the connector pins on the terminals for play and oxidi-
sation.
Code 203
Description CPU or memory fault on the drive regulator
Error mode Drive regulator error
Error cause 1. Defective drive regulator
Comments
Code 205
Description Overheated drive motor
Error mode Drive regulator error
Error cause 1. Motor overloaded
2. Defective cabling/temperature sensor
Comments Restart possible
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...