SMART KTF 2000 – KTF/100HP Operation
SMART KTF 2000 3A-9 -
Functions Available within the CONTROL Environment
(Counter Reading)
ErT = Number of “Tension” errors detected
E2 = Number of “E2” errors detected (see KTF/100HP Manual, Chapter 4 for details)
E3 = Number of “E3” errors detected (see KTF/100HP Manual, Chapter 4 for details)
ET- = Number of errors due to negative Tolerance limit exceeded
ET+ = Number of errors due to positive Tolerance limit exceeded
The Counter Reading function can be activated only if it was enabled in the APPLIC menu item. (CNT Alm).
System Monitoring
Main Menu
Displaying the fault
counters-total
Displaying the fault counters
on individual Devices
Clearing all counters
Clearing counters
relating to KTF DDD
Increase the device
number DDD
Decrease the device
number DDD
To Next Page
Loading...
