btsr SMART KTF 2000 - Operating Notes about the TARGET Function

SMART KTF 2000 – KTF/RW Operation
SMART KTF 2000 3B-11 -
Operating Notes about the TARGET Function
The TARGET function (normally enabled for REWIND application only), allows
you to program the quantity of yarn to be wound on a bobbin, and then to transmit
the programmed value to the KTF/RW devices.
When reaching the TARGET, the relevant device will display a STOP TARGET
message and will light-up the Front Red LED.
On SMART KTF 2000 terminal you will see, in real time, the quantity of yarn fed
by the selected KTF. When reaching the TARGET, the display of SMART KTF
2000 terminal will show the message TARGET!
KTF> NN (where NN is the number of relevant devices).