168 cab Produkttechnik GmbH & Co KG
168
PRODUCT MARKING AND BARCODE IDENTIFICATION
Hermes
Apollo
A-series
This
function is
available
for:
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX][ESC][i][L][S]
M-series
X - Synchronous Peripheral Signal Settings
The X command can be used to control external devices.
X y[;ao] CR
X = Synchronous Peripheral Signal Setting Command
y = Printing coordinate when a signal should be set. Distance from print start
to start of the signal in millimeters or inches. (See the m command for the
measurement settings.
ao= hex nibbles to set or to reset the signal
Function and settings depend on the used printer type and the peripheral connector. Please refer to
the operator´s manual and to the documentation for the optional devices for each printer model.
The "X" command needs to be placed after the definition of the page size ! ("S"- command)
Syntax:
To Next Page
Loading...
