cab Produkttechnik GmbH & Co KG 27
27
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX]
Hermes
Apollo
A-series
This
function is
available
for:
[ESC][i][L][S]
PRODUCT MARKING AND BARCODE IDENTIFICATION
M-series
ESC commands
are responsible for status queries, control functions, memory management etc. and are usually
executed immediately, i.e. even if a printing job runs. They are not absolutely required to print labels,
but they offer additional features and possibilities.
ESC commands cannot be handled by the most text editors. All other commands can be transmitted
to the printer by using simple text editors.
ESC commands are used for activating printers via RS-485, while the printers are "listening" to the
bus, for resetting printers, requesting for free memory or for getting a direct status request.
Details about each command are described on the following pages.
CHAPTER 2 - ESC Commands
To Next Page
Loading...
