CAB A Series - PEEK Variables

cab Produkttechnik GmbH & Co KG 239
239
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX]
Hermes
Apollo
A-series
This
function is
available
for:
[ESC][i][L][S]
PRODUCT MARKING AND BARCODE IDENTIFICATION
M-series
PEEK Variables:
„os“ Delivers „cab A-Series“ - only for compatibility with Yabasic
„version“ Version of Yabasic
„resolution“ Resolution of printer in dpi
„width“ Maximum print width in mm
„transparent“ Value: 0 or 1. 1 switches off ESC-command interpretation
„mlength“ measured length of last label distance (mm), if not known it is 0
„direction“ direction of paper move - 1 if forward, -1 if backwards and 0 if standing
„slength“ stored label distance (mm), if not known or invalid it is 0
this is effectively the distance of the last defined label before being switched off
„imageheight:name“
gives the height of an image „name“ in dots, 0 if not known
„imagewidth:name“
gives the width of an image „name“ in dots, 0 if not known
„freememory“
gives the free main memory (available for abc or Jscript)
„status“ state of the printer (same as ESC s answer string)
„xinput“ status of the peripheral connector input pin (XSTART)
„xoutput“ reads actual peripheral control bits
„line“ number of the actually printed label
„jphase“ Phase of JScript-Interpreter:
0 waiting for label definition
1 in process of label definition
2 during printing
3 standby, waiting for new job or new data for old one
„source“ Name of last data source:
„RS232“, „RS422“, „RS485“, „IEEE1284“, „RAWIP“, „USB“, „unknown“
„ticks“ timer tick since startup of printer in 1/128th seconds
„sec70“ time in unix format - i.e. seconds since Jan 1, 1970.
no
no