cab Produkttechnik GmbH & Co KG 47
47
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX]
Hermes
Apollo
A-series
This
function is
available
for:
[ESC][i][L][S]
PRODUCT MARKING AND BARCODE IDENTIFICATION
M-series
a - ASCII Dump Mode
The a command starts the ASCII dump mode. The ASCII dump mode shows all received data and is
a very important instrument to detect wrong data in the program code.
The printer´s LCD panel shows "ASCII dump mode" in the selected language.
All received data is printed "transparent" and the printer doesn´t interpret it.
Apollo -Series, A8 and Hermes-Series:
Pressing the on-line (ONL) button on the printer’s front panel resets the printer to its normal mode of
operation. This mode can also be entered by holding down the form feed key while powering the
printer on.
A-Series
The ASCII Dump Mode is selectable through the navigatorpad like shown in the picture below.
Note: After ASCII Dump Mode is selected you must confirm this selection with the ENTER button of
the navigator pad.
a
CR
The following data creates a label with one line of text. Please view the picture below which shows the
same label in ASCII Dump mode.
a
J
S l1,0,0,68,70,100
T 25,25,0,3,13;ASCII Dump Mode
A1
f
If "protocol errors" are shown on the label means, that there is a mistake in the program code!
Syntax:
Example:
To Next Page
Loading...
Need help?
General
