240 cab Produkttechnik GmbH & Co KG
240
PRODUCT MARKING AND BARCODE IDENTIFICATION
Hermes
Apollo
A-series
This
function is
available
for:
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX][ESC][i][L][S]
M-series
POKE Variables:
„xoutput“ status of the peripheral connector control bits (output)
Note: you have to set the peripheral mask to 0 (x m command) before!
„read_controls“ Value: 0 or 1. 1 allows control characters to pass thru INPUT or INKEY$.
All characters are passed to abc, including the character terminating
the input line (e.g. CR). (This CR can be removed e.g. with TRIM$.)
„bypass“ Value:0 or 1. 1 allowsdata from interfaces to go directly to JScript.
„httpswap“ Can be used to swap the normal root directory and the memory card
on the webserver. E.g. POKE „httpswap“,“/secret“ moves the applet
to /secret/index.htm and /card/index.htm to /index.htm.
„lcd“ Controls the source for the LCD. 0 is standard, JScript content. 1 is the abc window.
„lcdx“, „lcdy“ Offset for the LCD in the abc window.
„led“ Controls the state of the front panel LEDs (if „lcd“ is 1). Bit coded:
1 = Cancel
2 = Mode
4 = Feed
8 = Pause
16 = Arrows
„ledmask“ Masks the LEDs to be lit. Independent of „led“ -value. Same bit coding as „led“.
A 0 masks the respective LED.
„backlight“ Controls the backlight of the LCD of „lcd“ is 1. 1 is on, 0 is off, 2 is controlled
by JScript (Default).
„fcolor“, „bcolor“ Sets the fore- and background colors for abc window operations.
„color#x“ Sets the RGB value for color #x. x is valid from 1 to 254. Color 0 (black)
and 255 (white) cannot be modified.
„nice“ Sets the multitasking priority of abc vs. JScript. Ranges from 1 (JScript fast)
to 20 (abc fast). Default is 10.
„key“ Puts a character into the key buffer. E.g. POKE „key“,dec(„F001“) simulates
pressing the MODE key.
no
no
To Next Page
Loading...
