CAB A Series - Page 61

cab Produkttechnik GmbH & Co KG 61
61
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX]
Hermes
Apollo
A-series
This
function is
available
for:
[ESC][i][L][S]
PRODUCT MARKING AND BARCODE IDENTIFICATION
M-series
q - query Printer
q l;name CR
Query for label. Requests if the label ( LBL ) file called "name"is available.
q m CR
Query for the memory card type Answer: Format „type, xxx kByte.CR“, - The
response will be „No card.CR“ if no memory card is attached to the printer
q p CR
Query for peripheral equipment. Reports the type of peripheral devices that
are connected. Possible responses are:
NONE, CUTTER, REWINDER, DEMAND SENSOR, BLOW ON, TRIGGER
(Applicator) Possible answers depend on the printer type and it´s available
options !!
Used to verify if a label can be processed on the selected printer. Very helpful if
multiple printers with different peripheral equipments are connected.
q r CR
Query for ribbon diameter. Answer: diameter of the ribbon roll in millimeters.
If the ribbon roll has not been measured, the answer will be -1
(A-Series only , Firmware version V2.81 or higher.)
Can be used to get a early warning when the ribbon is close to be finished.
q s;name CR
Query for scaleable fonts. Answer Y/N or C if the font had been found on the
memory card.
This command is used to check if a specified font is available, to find out if it has
to be downloaded (again).
q t CR
Query for time and date Answer: yymmddhhmmss CR
Time and date format is identical to the "s" -command.
Used to find out if the printer´s date and time must be synchronized or to keep
track when a label was printed.
Syntax:
Syntax:
Syntax:
Syntax:
Syntax:
Syntax: