806SA-0120
CLOCK
+
RIOCN8WS
RIOLX8WS
RIOPH8WSRIOED8WS
p. 24 - Manual FA01274-EN - 11/2018 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. Original instructions
Rio System Wireless devices
Plug-in radio-control module for managing safety and warning devices over radio frequencies.
Plug the RIOCN8WS card into the corresponding connector on the control board.
Set the function to be associated with the following wireless devices: [RIO ED T1], [RIO ED T2], [RIO PH T1] and
[RIO PH T2], when programming.
Confi gure the RIOED8WS, RIOPH8WS and RIOLX8WS wireless accessories by following the indications shown in
the folder enclosed with each accessory.
If the devices are not confi gured with the RIOCN8WS module, the display will show the [RIO system not
confi gured] error message.
⚠
If the system's radio-frequencies are disturbed, the wireless system will prevent the operator from functioning
normally, and the [RIO system is unreachable] will appear on the display.
Timer device
This lets you view the date and time, set the way you want the operator and the B1-B2 auxiliary contact to
function, by turning them on at a preset time.
Plug the CLOCK card into the connector on the control board.
For more details, see the MANAGE TIMER paragraph in the PROGRAMMING chapter.
To Next Page
Loading...
Need help?
General
