p. 36 - Manual FA01274-EN - 11/2018 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. Original instructions
Guided procedure (Wizard)
See the chapter called COMMISSIONING.
External memory
[Saving data]
To save the users, time settings and confi gurations stored in the memory roll.*
[Reading data]
To upload the data stored in the memory roll.*
* See the chapter called SAVING AND UPLOADING DATA USING THE MEMORY ROLL
RSE communication
[RSE1] ➡ [O ] > [Combined] > [CRP]
Confi gure the RSE1 connector as: [Combined] = to work in MASTER mode for controlling the two operators;
[CRP] = remote connection system or [O ].
[CRP Address] ➡ [1] > ... > [255]
Associate an address number that uniquely identifi es each control board, when the system has two or more
operators and a remote connection system.
[RSE1 speed] ➡ [1200 bps] > [2400 bps] > [4800 bps] > [9600 bps] > [1200 bps] > [14400 bps] >
[19200 bps] > [38400 bps] > [57600 bps] > [115200 bps]
To set the communication speed used in the remote connection system on the RSE1 port.
[RSE2 speed] ➡ [1200 bps] > [2400 bps] > [4800 bps] > [9600 bps] > [1200 bps] > [14400 bps] >
[19200 bps] > [38400 bps] > [57600 bps] > [115200 bps]
To set the communication speed used in the remote connection system on the RSE2 port.
To Next Page
Loading...
Need help?
General
